THERMOSHIELD NANO PLATINUM INTERIOR

Insulation that takes up no living space

Interior insulation has a fundamental problem: every centimetre of insulation reduces your room. THERMOSHIELD NANO PLATINUM INTERIOR does not. It is applied in a single coat of 3–4 mm — thinner than a tile — and achieves a thermal insulating effect that would otherwise require bulky insulation.

How it works

The ceramic nanoparticles dispersed in the mass form, when dry, a continuous heat-reflective structure that returns up to 93 % of the thermal radiation that would escape through the wall to the interior. Heat is distributed evenly: the typical feeling of a “cold wall in a warm room” disappears. Product compliant with EN ISO 13786 standard.

End to mould in corners and behind furniture

Mould grows where moist air condenses on a cold surface: in corners, door jambs, behind wardrobes. This plaster addresses the cause, not the symptom: it raises the surface temperature of the wall to prevent condensation and also protects the surface against mould and microorganisms. It is fully breathable: the wall keeps breathing.

Hard surface that lasts

Once cured it forms an extraordinarily hard and wear-resistant structure — it withstands daily use in hallways, stairs, children’s bedrooms or commercial spaces, unlike soft insulation boards under plasterboard.

Bonds to almost any substrate

Masonry, concrete, plasterboard, OSB, wood, metal and sheet metal. The substrate just needs to be level, cohesive and dry. Also ideal for remediation of thermal bridges where classic insulation does not fit: door and window jambs, lintels, pillars, metal structures.

Key properties

• Reflects up to 93 % of thermal radiation
• Single coat of 3–4 mm — does not reduce usable floor area
• Eliminates condensation and prevents mould
• Fully breathable
• Very hard surface and resistant to abrasion
• Bonds to masonry, concrete, plasterboard, OSB, wood and metal
• Suitable for walls and ceilings
• Supplied as ready-to-use paste — just mix

Technical data

Application in 4 steps

1. Prepare the substrate: level, cohesive, dry, free of dust and grease.
2. Mix the contents of the container with a mixer at low speed until homogeneous.
3. Spread with a stainless steel notched trowel in a coat of 3–4 mm.
4. Smooth with a rubber float to close and unify the surface. One coat usually suffices.

📄 Technical data sheet (ES) — PDF
📄 Specific properties (ES) — PDF